The operation temperature of industrial vacuum dust collector enterprise should be considered according to the long-term operation temperature, in order to avoid condensation, Generally, the flue gas temperature of industrial vacuum dust collector enterprise should be kept 15 to 20 degrees higher than the dew point. When purifying the high temperature gas whose temperature is close to the dew point, the relative humidity of the gas should be reduced by indirect heating or mixing with high temperature gas.

When running an industrial vacuum dust collector enterprise, you need to observe the status of the differential pressure system to check whether faults exist. The pressure difference value of the pressure difference system of industrial vacuum dust collector enterprise should be accurately recorded. If the pressure difference is sudden during the recording process, it is necessary to check the filter bag to see whether there is blockage or dust compaction. At the same time, the cleaning system should be accurately checked to avoid excessive ash accumulation in the ash hopper. If there is a sudden drop in the recording process, it may be that the filter bag is damaged or falling off.

industrial vacuum dust collector enterprise has the advantages of simple structure, low investment cost, simple operation, management and maintenance technology. When the flue gas containing dust enters the middle and lower boxes through the inlet of the dust collector, the dust is adsorbed on the filter bag, and the gas enters the upper box through the Wenshili tube through the filter bag, and is discharged from the outlet. With the accumulation of dust on the filter bag, the pressure loss of the filter bag increases gradually, and the pressure loss is fed back to the controller by the pressure gauge. The controller receives and sends out instructions to trigger each pulse solenoid valve in sequence, so that the gas in the air bag is immediately ejected from each hole of the blowpipe, and the inner tube is ejected into the corresponding filter bag. The filter bag does not expand slowly under the instantaneous reaction of the air flow, so that the dust accumulated on the surface of the filter bag falls off, and the filter bag can be recycled for reuse. Field observation of a large number of damaged filter bags shows that the damaged parts of filter bags are almost circular holes and long cracks. The test also showed that the undamaged part of the damaged filter bag and other filter bags in the filter unit were not significantly deformed, and the good residual rate was basically normal. This shows that the polymer fiber filter media in use did not occur significant cracking.

industrial vacuum dust collector enterprise https://www.kaisenfilter.com/KSG-1-0-B-High-Vacuum-Fume-Extractor.html